Submerged Cutting

  • Water Raise/Lower for Submerged Cutting

    Water Raise/Lower for Submerged Cutting

    For many abrasive waterjet applications, underwater submerged cutting is the best solution. For materials like steel, stainless, aluminum, copper, bronze, inconel, titanium, and other metals, as well as materials like glass, stone, marble, granite, etc., submerged cutting offers two big advantages:

    1) Reduced Noise

    • A typical abrasive waterjet stream travels over three times the speed of sound and as it travels through the air, the turbulent passing air generates noise levels over 100 dB, even as high as 120 dB.
    • by raising the water level and submerging the material, "the operating noise level" is reduced below safety limits because the high pressure water stream is underwater and the stream is not exposed to the air, minimal noise is created and it is "trapped" underwater.
    • Submerged cutting noise levels usually remain below 78 dB while normal conversation can take place standing right next to the waterjet.

    2) Less Mess

    • The typical high pressure waterjet piercing process results in an abrasive jet stream that "rooster tails" back into the environment for the duration of the pierce, anywhere from just a few seconds on the thin materials, up to several minutes, depending on the thickness and hardness of the material.
    • If the material is not submerged, that diffused stream shoots back into the environment, and literally gets everywhere including on the beams, rails, bearings, controller, electronics and anywhere else.
    • As the abrasive stream shoots upward, an abrasive mist is created and rises, which consequently settles, and then contaminates the entire work area. Customers without submerged cutting often have to isolate their machines away from all other machines in their shop.

    Water Raise/Lower for Submerged Cutting

    Price:

    Testimonials

    "[Tech-Senseā„¢] saves on scrap parts and cuts down on wasted time by alerting us if the nozzle is clogged or if we run out of abrasive. This allows you to walk away and perform other tasks while the machine is running"

    - C & R Manufacturing >>

    Share with Friends and Colleagues

    Free Video Report

    Fill out your information below to immediately receive access to view our FREE video report: 7 Things You Should Know Before Buying a Waterjet.

    Captcha Image
  •  
0