Advantage UHP Pump

H2O Jet Pump Flyer PDF

Single intensifier, 60K and 40K psi, 50 hp motor

H2O Jet continues to set the standard with the Advantage UHP pump series. This industrial workhorse
provides the best solution to your waterjet needs. The Advantage Pump maintains maximum pressure and flow
rate with the lowest pressure fluctuation throughout the complete ultra high pressure range of cutting
parameters. This insures minimum downtime and increases productivity.

The Advantage is ideal for both water-only and abrasive waterjet cutting applications. The operator friendly
features provide real time diagnostics; quiet operation and easy access to all internal pump components, and
the intensifiers are mounted at tabletop height for ease of maintenance.

Advantage Pump Features

1. 1) Six models supporting orifice sizes up to .025″
2. 2) Up to two gpm flow rate at 60,000 psi
3. 3) Ergonomic, accessible design with removable
4. doors and covers, tabletop intensifier height
5. 4) Constant maximum pressure with minimum
6. pressure fluctuation
7. 5) Quiet operation, less than 80 dB
8. 6) User friendly operator interface with touch-screen
9. controls and diagnostics
10. 7) Motor Starter included (Optional Wye-Delta)
11. 8) Superior Reliability

Ergonomic Design

• Designed for maintenance accessibility
• Forklift ports on front, rear and sides
• Drip pan collects and transfers any leak to a removable reservoir
• Sealed base captures up to 30 gallons in case of a major oil spill
• Covers swing open with lift-off hinges for easy, unobstructed access
• Rugged powder-coated finish on frame and covers for lasting durability

Quiet Operation

• Sound dampening insulation on all doors and panels
• Less than 80 dB
• Motor and pump unit is mounted on sound/vibration isolation bars

Attenuator

• Large 135 cu. in. volume minimizes pressure spikes
• Mounted in sound-dampening brackets
• Minimizes pressure fluctuations at the cutting head
• Provides consistent jet stream flow
• Enhances crisp, clean cuts for high quality results
• Adds life to downstream, fatigue prone components

Hydraulics

• Variable displacement, pressure-compensated axial piston pump
• Oil recirculation pump continuously cycles oil through the filter and high efficiency heat exchanger
• Oversized suction and pressure lines for increased oil flow with less pressure drop
• Large 80 gallon reservoir enhances the life of the operating oil

Controls

• Automatic resettable stroke counters provide
• precise information for performance analysis
• Allen Bradley PLC Controller
• Touch screen operator interface
• Diagnostic messaging provides continual
• monitoring of all critical operating parameters
• Electronic Pressure Control

Water

• Custom dual-filtration manifold
• Stainless steel water booster pump
• Automatic high pressure water bleed down

Model Intensifiers

• Maximum Operating Pressure: 60,000 psi (4150 bar)
• Flow Rate: 1 gpm (7.6 l/min)
• Maximum Orifice Size: .014″ (.508 mm)
• Horsepower: 50 hp (74.57 kw)
• Hydraulic Reservoir Capacity: 80 gal (302.8 l)
• Cooling Water Flow: 3-5 gpm (11.4-20 l/min)
• Length: 79″; (201 cm)
• Width: 49″ (124.5 cm)
• Height: 51″ (129.5 cm)
• Weight: 4,000 lb (1814.36 kg)