This remarkable patented technology will dramatically
increase your profitability by reducing scrap,
increasing up-time, reducing labor and
No longer will you require a person to stand
idle and watch a machine ‘just in case’ there
is a problem. The Tech-Sense™ will warn the
operator with an audible alarm and flashing
light if the machine is not running efficiently,
and will pause the machine if the problem could
potentially damage the part or material being cut.
When integrated with the “SMS Offsite Notification”
you are free to leave the site altogether, making “Lights
Out” operating a reality.
Potential Problems Detected
- Low abrasive being delivered to the cutting head –
Possible cause – Moist abrasive, blocked feed line due
to foreign particles or kinked feed hose.
- Plugged focusing tube –
Possible causes – Focusing tube too close to work
piece, foreign material in tube.
- Damaged orifice –
Possible causes – General wear or erosion, foreign
particle, poor water quality.
- Water pressure drop –
Possible causes—Intensifier problem, high pressure
hose leak, dump valve leak, cutting head leak.
- Worn or damaged focusing tube
- Inefficient cutting head set up –
Possible causes — Too much or too little abrasive,
cutting head loose, focusing tube not seated, orifice
not assembled properly